4PCS Single Spray Humidifieration Atomization Plate Disc Type-C Interface DC 5V USB Atomization Drive Circuit Board with Timing Switch

Humidifier Module Parameter: Rated Voltage: DC 5V Rated Current: 300mA Power Type: Type-C Humidifier Interface: PH2.0 terminal PCB Size: 35*19mm, Weight: 4g Frequency: 108KHz+3 Power: 1.5-2W Atomization amount: Around 40-50ml/h Work Temperature: 0℃~85℃ Work Humidity: 10%~90%RH Microporous Atomizing Film Parameter: Steel Sheet Diameter: 16mm Outer Diameter of Silicone Ring: 20mm Cable Length: 100mm Weight: 2g Frequency: 108KHz+3 Aperture: 4-5μm Number of Holes: 740 holes Interface: PH2.0 terminal Material: Piezo ceramic ring + Stainless steel Humidifier Cotton Swab Size: 100*10mm, Weight: 1.5g Black Bracket Size: 38*24mm, Weight: 4g DIRECTIONS FOR USE: 1. Attach the atomizer to the circuit board. 2. Power supply USB DC 5V. 3. Press the circuit board switch. 4. Atomizing plate suction water spray.

• Two spray modes: press the switch for the first time is continuous spray mode: LED light is always on, always spray, spray 4 hours after the automatic shutdown protection. Press the switch for the second time is indirect spray mode: LED flashes, spray 10 seconds, stop spraying for 5 seconds, and so on, spray 12 hours after the automatic shutdown protection. Press the switch for the third time to turn off the machine.
• Pay attention to the front and back sides during installation: The white piezoelectric ceramic ring surface is the front spray surface, which is installed upward, All steel sheet surface is the suction surface on the back, installed downwards.
• High-frequency oscillation, micrometer aperture, large atomization amount, fine mist particles, high spray rate, spray variety, timed shutdown.
• Application: DIY spray, plant humidification, landscaping atomization.
• Package Inlcuding 4 Sets Atomization Module Kits (Atomization Module Type-C interfacet + Microporous Atomizing Film + Humidifier Cotton Swab + Black Plastic Bracket)